I'm about as green as it gets, so I hope this isn't a stupid question. I'm super-excited to give DIY a try, so I opened my Speedster kit today, and ran into a question right off the bat. It looks like the crossover specifies a 10 Ohm resistor, but my package came with two 100 Ohm resistors (the other two are 8.2 Ohms). Is this a problem?
While I'm asking questions, I also wondered about solid wood baffles. I've noticed a few of these on DIY boards, but I've always been advised to allow for movement in solid wood (floating panels, breadboard ends, z-clips, etc.). Are there any structural concerns with gluing a solid-wood baffle to a plywood box?
Thanks in advance for your advice!