Support for the DIY speaker builder

Topic Author
Posts: 1
Joined: Wed Oct 18, 2017 5:43 pm

Speaker/crossover design

Wed Oct 18, 2017 6:09 pm

I'm experimenting with a speaker design and would appreciate any feedback. I'm definitely a newbie when it comes to this. Attached is a crudely drawn schematic and a picture of the built and minimally tested crossover. The crossover is based off of speakers that I have and like.

6-1/2" Poly Cone Midbass Woofer 4 Ohm
Goldwood GT-520 1" Soft Dome Horn Tweeter

Crossover parts:
12uF 100V Electrolytic Non-Polarized Crossover Capacitor
Dayton Audio DNR-1.0 1 Ohm 10W Precision Audio Grade Resistor
Dayton Audio 0.20mH 20 AWG Air Core Inductor Crossover Coil
Jantzen Audio 0.56mH 18 AWG Air Core Inductor Crossover Coil
TE Connectivity Raychem RXEF050 0.50A Polyswitch Speaker Protector


crossover.gif (6.33 KiB) Viewed 753 times

Who is online

Users browsing this forum: No registered users and 1 guest