Bass box 6 Pro/X-Over 3 Pro software
Posted: Sat Feb 13, 2016 6:46 pm
Hi everyone,
I'm new here at the forum. I have been building speakers since I was a teenager. That's a long time. These were allways designed by others. I have just recently tryied my hand at speaker design using BassBox/Crossover Pro software. My first attemet was a amall two way for my computer. It used a Vifa dome tweeter and a 4" poly cone woofer. I think it turned out well.
Now I would like to try something a little bit more chalenging. I am thinking of a three way using all Scan Speak drivers. Woofer, 26W/8861T00, mid ,18W8531G00 and tweeter AirCirc D3004/6600. Unfortunately the crossover design portion of the software does not have the frequency response or impedance information for these or any Scan Speak drivers. Does anyone out there know where I can get this information to import into my software? Thanks.
I'm new here at the forum. I have been building speakers since I was a teenager. That's a long time. These were allways designed by others. I have just recently tryied my hand at speaker design using BassBox/Crossover Pro software. My first attemet was a amall two way for my computer. It used a Vifa dome tweeter and a 4" poly cone woofer. I think it turned out well.
Now I would like to try something a little bit more chalenging. I am thinking of a three way using all Scan Speak drivers. Woofer, 26W/8861T00, mid ,18W8531G00 and tweeter AirCirc D3004/6600. Unfortunately the crossover design portion of the software does not have the frequency response or impedance information for these or any Scan Speak drivers. Does anyone out there know where I can get this information to import into my software? Thanks.